Standard
UPDATE AVAILABLE
AS 2548.1-1998
[Superseded]Battery chargers for lead-acid traction batteries, Part 1: Battery chargers for vented cells
Specifies requirements for the design, testing and performance of battery chargers for charging vented lead-acid batteries used in traction applications, e.g. forklift trucks. Includes graphs of maximum charging current version cell voltage.
Published: 05/01/1998
Pages: 12
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
PREFACE
1 SCOPE
2 REFERENCED DOCUMENTS
3 DEFINITIONS
4 COMPLIANCE WITH OTHER STANDARDS
5 CLASSIFICATION
6 DESIGN AND CONSTRUCTION
6.1 Input connections
6.2 Output connections
6.3 Indicating Devices
6.4 Short-circuit protection
7 PERFORMANCE REQUIREMENTS
7.1 Temperature range
7.2 Charger time rating
7.3 Charger current rating
7.4 Termination of normal charge
7.5 Charge profile regulation
7.6 Single-stage taper charger
7.7 Two-stage taper charger
7.8 Maximum starting and finishing currents for Type B chargers
7.9 Equalizing charge
7.10 Percentage ripple current
7.11 Termination of charge due to a fault condition
8 MARKING
APPENDIX A
APPENDIX B
B1 SCOPE
B2 PRINCIPLE
B3 APPARATUS
B4 PROCEDURE FOR CHARGER CURRENT RATING AND RIPPLE CURRENT PERCENTAGE
B5 CALCULATION OF THE PERCENTAGE RIPPLE CURRENT
B6 PROCEDURE FOR CHARGE PROFILE REGULATION
B7 DETERMINATION OF CHARGE PROFILE REGULATION
B8 REPORTING OF RESULTS
APPENDIX C
Cited references in this standard
IEC 51-2
Direct acting indicating analogue electrical measuring instruments and their accessories, Part 2: Special requirements for ammeters and voltmeters
[Current]
Approval and test specification - General requirements for electrical equipment
One-time Purchase
Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^
$83.52 AUD
Inclusive of GSTFormat *
Web Reader
Licenses *
1 user
Total$83.52 AUD
IMPORTANT