Standard
Track updates
AS 2403-2008
[Current]Metallic materials — Sheet and strip — Determination of plastic strain ratio
Specifies a method for determining the plastic ratio of flat products (sheet and strip) made of metallic materials.
Published: 06/06/2008
Pages: 8
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
Preface
1 Scope
2 Referenced documents
3 Definitions
4 Notation
5 Principle
6 Test equipment
7 Test piece
7.1 Type and preparation
7.2 Thickness
7.3 Surface
7.4 Longitudinal axis
7.5 Reduced section test pieces
7.6 Parallel test pieces
8 Procedure
8.1 Testing temperature
8.2 Manual assessment
8.3 Automatic measurement
8.4 Strain rate
8.5 Applied strain rate
8.6 Strain level
8.7 Measuring gauge length and width (manual determination)
8.8 Measuring gauge length and width (automatic determination)
8.9 Invalid test
8.10 Non-homogeneous plastic strain
8.11 Coated materials
9 Expression of results
9.1 Manual determination
9.2 Homogeneous deforming behaviour
9.3 Calculated values
9.4 Difference between automatic and manual determination
10 Test report
Cited references in this standard
One-time Purchase
Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^
$83.52 AUD
Inclusive of GSTFormat *
Web Reader
Licenses *
1 user
Total$83.52 AUD
IMPORTANT