Standard
Track updates
AS/NZS 1418.9:1996
[Pending Revision]Cranes (including hoists and winches), Part 9: Vehicle hoists
Specifies the requirements for vehicle hoists as defined in AS 2549. It applies to wheel-supporting, axle-supporting and frame-supporting vehicle hoists, but does not apply to vehicle jacks, trolley jacks, car stackers or vehicle roll-over equipment. Sections are included on their design, installation, testing and operation and maintenance requirements. Appendices provide guidance on deflection limits, hazards and illustrations of typical vehicle hoists. It is intended for use with AS 1418.1 and AS/NZS 2550.9 which provides guidance on the safe use of vehicle hoists.
Published: 05/10/1996
Pages: 28
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
PREFACE
1 SCOPE AND GENERAL
1.1 SCOPE
1.2 NEW DESIGN AND INNOVATIONS
1.3 TYPES
1.4 REFERENCED DOCUMENTS
1.5 DEFINITIONS
1.6 RATING VALUES
1.7 RATED CAPACITY
1.8 RANGE OF HOISTING
1.9 WORKING VELOCITIES
1.10 TEST CERTIFICATE
1.11 MARKING
2 DESIGN
2.1 BASIS OF DESIGN
2.2 CLASSIFICATION
2.3 DESIGN FOR STRENGTH
2.3.1 General
2.3.2 Load distribution
2.3.3 Loading combinations
2.4 DEFLECTION
2.5 LATERAL LOADING
2.5.1 General
2.5.2 Horizontal loading
2.5.3 Wind loading
2.5.4 Seismic loading
2.6 STABILITY
2.7 WORKING VELOCITIES
2.8 SAFETY DEVICES
2.9 IMPACT FORCES
2.10 WELDS
2.11 ELECTRICAL EQUIPMENT AND CONTROLS
2.12 HYDRAULIC EQUIPMENT AND CONTROLS
2.13 PNEUMATIC EQUIPMENT AND CONTROLS
2.14 BURSTING SAFETY FACTOR FOR HYDRAULIC AND PNEUMATIC SYSTEMS
2.15 COMPONENTS
2.15.1 Axle and chassis supports
2.15.2 Auxiliary adaptors
2.15.3 Ramps
2.15.4 Runways
2.15.5 Safety locking of arms
2.15.6 Support pads
2.15.7 Wheel stops (wheel supporting hoists)
2.15.8 Anti-creep device
2.15.9 Dropper bars
2.15.10 Fixed platforms, walkways and ladders
2.15.11 Surfaces
2.15.12 Protection of personnel
2.15.13 Controls
2.16 VEHICLE HOISTS—HYDRAULIC
2.16.1 Low-oil control
2.16.2 Air/oil tanks
2.16.3 Air pocket elimination
2.16.4 Hydraulic system
2.16.5 Packing
2.16.6 Speed control
2.16.7 Pressure relief valve setting
2.17 VEHICLE HOISTS—MECHANICAL
2.17.1 Steel wire rope or chain suspension
2.17.2 Screw-suspended vehicle hoists
2.18 VEHICLE HOISTS—HYDROMECHANICAL
2.19 VEHICLE HOISTS—MOVABLE
2.20 HOIST MOTION LIMITS
2.21 MAINTENANCE
2.21.1 Accessibility for maintenance
2.21.2 Lubrication
3 INSTALLATION
3.1 GENERAL
3.2 SAFETY COLOUR CODING
3.3 PROTECTION OF HYDRAULIC CYLINDER CASING
3.4 LOCATION OF VEHICLE HOISTS
3.5 VEHICLE CLEARANCE
3.6 FUNCTIONAL TESTS
3.7 DEMONSTRATION
4 TYPE TEST REQUIREMENTS
4.1 GENERAL
4.2 UNLADEN TESTS
4.3 TEST LOADS
4.4 LADEN TESTS
4.5 COMPLIANCE WITH TESTS
5 OPERATION AND MAINTENANCE INSTRUCTIONS
5.1 GENERAL
5.2 INFORMATION FOR MAINTENANCE TECHNICIANS
5.3 SUITABILITY FOR USE
APPENDIX A
APPENDIX B
APPENDIX C
C1 GENERAL
C2 SAFETY DISTANCES
Cited references in this standard
[Current]
Fixed platforms, walkways, stairways and ladders — Design, construction and installation
[Current]
Fixed platforms, walkways, stairways and ladders — Design, construction and installation
[Available Superseded]
Minimum design loads on structures (known as the SAA Loading Code), Part 2: Wind loads
$113.50
AUD
Inclusive of GST
Available formats
Web Reader
Licence:
1 user
Total
$113.50
