Standard
AS/NZS ISO 10012:2004
[Withdrawn]Measurement management systems — Requirements for measurement processes and measuring equipment
Provides guidance and specifies generic requirements for the management of measurement processes and metrological confirmation of measuring equipment used to support and demonstrate compliance with metrological requirements. AS/NZS ISO 10012 is not intended to be used as a substitute for, or an addition to, ISO/IEC 17025, nor as a requisite for demonstration conformance with ISO 9001, ISO 14001 or any other Standard. It is identical with, and has been reproduced from, ISO 10012:2003.
Published: 09/06/2004
Pages: 19
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
Preface
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Management responsibility
5.1 Metrological function
5.2 Customer focus
5.3 Quality objectives
5.4 Management review
6 Resource management
6.1 Human resources
6.1.1 Responsibilities of personnel
6.1.2 Competence and training
6.2 Information resources
6.2.1 Procedures
6.2.2 Software
6.2.3 Records
6.2.4 Identification
6.3 Material resources
6.3.1 Measuring equipment
6.3.2 Environment
6.4 Outside suppliers
7 Metrological confirmation and realization of measurement processes
7.1 Metrological confirmation
7.1.1 General
7.1.2 Intervals between metrological confirmation
7.1.3 Equipment adjustment control
7.1.4 Records of the metrological confirmation process
7.2 Measurement process
7.2.1 General
7.2.2 Measurement process design
7.2.3 Realization of the measurement process
7.2.4 Records of measurement processes
7.3 Measurement uncertainty and traceability
7.3.1 Measurement uncertainty
7.3.2 Traceability
8 Measurement management system analysis and improvement
8.1 General
8.2 Auditing and monitoring
8.2.1 General
8.2.2 Customer satisfaction
8.2.3 Measurement management system audit
8.2.4 Monitoring of the measurement management system
8.3 Control of nonconformities
8.3.1 Nonconforming measurement management systems
8.3.2 Nonconforming measurement processes
8.3.3 Nonconforming measuring equipment
8.4 Improvement
8.4.1 General
8.4.2 Corrective action
8.4.3 Preventive action
Annex A
A.1 Introduction
A.2 Customer metrological requirements (CMR)
A.3 Measuring equipment metrological characteristics (MEMC)
A.4 Verification and metrological confirmation
Bibliography
Cited references in this standard
$108.12
AUD
Inclusive of GST
Available formats
Web Reader
Licence:
1 user
Total
$108.12
