Standard
Track updates
AS/NZS 2111.4:1996
[Current]Textile floor coverings — Tests and measurements, Method 4: Determination of surface pile mass above the substrate
This Standard describes the procedure for determining the mass per unit area of surface pile, which can be cut from above the substrate of a textile floor covering. The surface pile mass per unit area can be expressed at its equilibrium condition or in terms of clean conditioned mass at agreed commercial allowances.
Published: 05/08/1996
Pages: 7
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
PREFACE
FOREWORD
1 SCOPE
2 REFERENCED DOCUMENTS
3 DEFINITIONS
4 PRINCIPLE
5 REAGENT
5.1 General requirements
5.2 Wetting agent
6 APPARATUS
7 SAMPLES AND TEST SPECIMENS
7.1 Sampling
7.2 Number and area
7.3 Preparation
8 PROCEDURE
9 CORRECTION FOR AGREED COMMERCIAL ALLOWANCE
9.1 General
9.2 Procedure
10 CALCULATIONS
10.1 The following shall be calculated:
10.2 Coefficient of variation (CV)
10.3 Calculation of corrected surface pile mass per unit area
11 REPORT
APPENDIX A
A1 NATURAL FIBRES
A2 MAN-MADE FIBRES
Cited references in this standard
[Superseded]
Method for sampling and cutting specimens of textile floor coverings for testing
BS 1752
Specification for laboratory sintered or fritted filters including porosity grading
One-time Purchase
Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^
$45.53 AUD
Inclusive of GSTFormat *
Web Reader
Licenses *
1 user
Total$45.53 AUD
IMPORTANT