Standard
UPDATE AVAILABLE
Track updates
AS/NZS 1595:1998
[Current]Cold-rolled, unalloyed, steel sheet and strip
Specifies requirements for cold-rolled, unalloyed, steel sheet and strip, supplied as both coil and cut lengths to chemical composition only, or to strength, hardness or formability requirements. It also specifies two surface finishes (lustre and matt) and three levels of surface quality.
Published: 05/07/1998
Pages: 15
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
PREFACE
1 SCOPE AND GENERAL
1.1 SCOPE
1.2 REFERENCED DOCUMENTS
1.3 DEFINITIONS
1.4 DESIGNATION
1.4.1 General
1.4.2 Analysis grades
1.4.2.1 A four-digit series designation
1.4.2.2 Modification symbol
1.4.3 Hardness grades
1.4.3.1 Third and fourth characters
1.4.3.2 Fifth character
1.4.4 Formability grades
1.4.4.1 Third character
1.4.4.2 Fourth character
1.4.4.3 Fifth character
1.4.5 Strength grades—third, fourth and fifth characters
1.5 ROUNDING OF TEST RESULT VALUES
1.5.1 General
1.5.2 Tensile properties
1.6 MARKING
2 MANUFACTURING REQUIREMENTS
2.1 SCOPE
2.2 STEEL-MAKING PROCESS
2.3 CHEMICAL COMPOSITION
2.3.1 General
2.3.2 Cast analysis
2.3.3 Product analysis (for analysis grades only)
2.4 FREEDOM FROM DEFECTS
2.5 MANUFACTURING TOLERANCES
3 MECHANICAL PROPERTY REQUIREMENTS
3.1 SCOPE
3.2 SELECTION OF TEST SAMPLES
3.2.1 Tensile, strain-age and plastic strain ratio tests
3.2.2 Bend tests
3.3 PREPARATION OF TEST PIECES
3.3.1 General
3.3.2 Test piece for the tensile, strain-age and plastic strain ratio tests
3.3.3 Test piece for the bend test
3.4 HARDNESS TEST
3.5 BEND TEST
3.6 TENSILE TEST
3.7 STRAIN-AGE TEST (Applicable to all non-ageing (stabilized grades))
3.8 PLASTIC STRAIN RATIO (r) TEST (Applicable to grades, CA4 and CA5SN only)
APPENDIX A
A1 GENERAL
A2 INFORMATION TO BE SUPPLIED BY THE PURCHASER
A3 STRAIN-AGE HARDENING
A4 SURFACE
A4.1 Surface finish
A4.2 Surface quality
A5 TEST REQUIREMENTS
A5.1 Product analysis
A5.2 Independent tests
A6 CERTIFICATES
A6.1 General
A6.2 Certificates of compliance
A6.3 Test certificates
A7 INSPECTION
APPENDIX B
B1 SCOPE
B2 STATISTICAL SAMPLING
B3 PRODUCT CERTIFICATION
B4 SUPPLIER’S QUALITY SYSTEM
B5 OTHER MEANS OF ASSESSMENT
B5.1 General
B5.2 Sampling
B5.3 Compliance
B5.4 Retesting
APPENDIX C
Cited references in this standard
[Superseded]
Guide to AS 1199 - Sampling procedures and tables for inspection by attributes
Content history
[Current]
[Superseded]
AS/NZS 1595:1998 Rec:2016
DR 97357
One-time Purchase
Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^
$83.52 AUD
Inclusive of GSTFormat *
Web Reader
Licenses *
1 user
Total$83.52 AUD
IMPORTANT