Standard
Track updates
AS/NZS 1567:2023
[Current]Copper and copper alloys — Wrought rods, bars and sections
AS/NZS 1567:2023 specifies requirements for wrought copper and copper alloy rods, bars and sections, including hollow sections, having a diameter or width across flats of not less than 1.6 mm, for machining and general purposes other than forging.
Published: 26/05/2023
Pages: 17
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
Preface
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
4.1 Alloy designation
4.2 Temper designation
5 Temper of material
6 Chemical composition
6.1 General
6.2 Chemical analysis
7 Mechanical properties
7.1 Selection and preparation of test samples
7.2 Tensile test
7.3 Hardness test
7.4 Bend test
8 Dezincification test
9 Stress corrosion cracking test
10 Electrical resistivity test
10.1 General
10.2 Conductivity
11 Hydrogen embrittlement test
12 Microstructure of alloy C68600
13 Rounding of test result values
13.1 General
13.2 Tensile test results
14 Retests
15 Freedom from defects
16 Marking
17 Manufacturing tolerances
17.1 General
17.2 Cross-sectional tolerances for drawn round rod and square bar
17.3 Cross-sectional tolerances for hollow rod
Appendix A
A.1 Purchasing information to be supplied
A.2 Test recommendations
Appendix B
Bibliography
Cited references in this standard
BS 1748 (all parts)
Methods for the analysis of copper alloys
ASTM E478
Standard Test Methods for Chemical Analysis of Copper Alloys
[Current]
Recommended practice for atomic emission spectrometric analysis, Part 1: Principles and techniques
One-time Purchase
Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^
$117.99 AUD
Inclusive of GSTFormat *
Web Reader
Licenses *
1 user
Total$117.99 AUD
IMPORTANT