Standard
Track updates
AS 681.2-2008
[Current]Elastomeric seals — Material requirements for pipe joint seals used in water and drainage applications, Part 2: Thermoplastic elastomers
Specifies requirements for materials used for moulded seals only of thermoplastic elastomers (TPE) used in joints of thermoplastic piping systems for gravity waste water discharge (intermittent flow up to 95 degrees Celsius) inside buildings, thermoplastic piping systems for gravity underground drainage and sewerage (continuous flow up to 45 degrees Celsius and intermittent flow up to 95 degrees Celsius), and thermoplastic rainwater piping systems.
Published: 05/02/2008
Pages: 16
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
PREFACE
1 Scope
2 Normative references
3 Definitions
4 Classification
5 Finished seal requirements
5.1 Dimensional tolerances
5.2 Imperfections and defects
5.3 Hardness
5.4 Tensile strength and elongation at break
5.5 Compression set in air
5.5.1 General
5.5.2 Compression set at 23 °C and 70 °C
5.5.3 Low temperature compression set at -10 °C
5.6 Accelerated ageing in air
5.7 Stress relaxation in compression.
5.8 Volume change in water
5.9 Ozone resistance
5.10 Optional requirement for type WH
6 Test pieces and temperature
6.1 Preparation of test pieces
6.1.1 General
6.1.2 Samples for determination of hardness
6.1.3 Samples for determination of tensile strength
6.1.4 Samples for determination of compression set
6.2 Test temperature
7 Factory production control
8 Factory product control tests
8.1 Sampling
8.2 Routine tests
8.3 Type tests
9 Storage
10 Designation
11 Marking and labelling
Annex A
Annex ZA
ZA.1 Scope and clauses of the European Standard addressing the essential characteristics of the EU Construction Products Directive
ZA.2 Systems of attestation of conformity
ZA.3 CE Marking
Cited references in this standard
[Current]
Rubber, vulcanized or thermoplastic — Resistance to ozone cracking — Part 1: Static and dynamic strain testing
[Current]
Rubber - Recommendations for the workmanship of pipe joint rings - Description and classification of imperfections
[Superseded]
Rubber, vulcanized or thermoplastic — Preparation of samples and test pieces — Part 1: Physical tests
[Current]
Sampling procedures for inspection by variables — Part 6: Specification for single sampling plans for isolated lot inspection indexed by limiting quality (LQ)
[Superseded]
Rubber, vulcanized or thermoplastic — Determination of stress relaxation in compression at ambient and at elevated temperatures
$113.50
AUD
Inclusive of GST
Available formats
Web Reader
Licence:
1 user
Total
$113.50
