Standard
Track updates
AS 681.2-2008
[Current]Elastomeric seals — Material requirements for pipe joint seals used in water and drainage applications, Part 2: Thermoplastic elastomers
Specifies requirements for materials used for moulded seals only of thermoplastic elastomers (TPE) used in joints of thermoplastic piping systems for gravity waste water discharge (intermittent flow up to 95 degrees Celsius) inside buildings, thermoplastic piping systems for gravity underground drainage and sewerage (continuous flow up to 45 degrees Celsius and intermittent flow up to 95 degrees Celsius), and thermoplastic rainwater piping systems.
Published: 05/02/2008
Pages: 16
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
PREFACE
1 Scope
2 Normative references
3 Definitions
4 Classification
5 Finished seal requirements
5.1 Dimensional tolerances
5.2 Imperfections and defects
5.3 Hardness
5.4 Tensile strength and elongation at break
5.5 Compression set in air
5.5.1 General
5.5.2 Compression set at 23 °C and 70 °C
5.5.3 Low temperature compression set at -10 °C
5.6 Accelerated ageing in air
5.7 Stress relaxation in compression.
5.8 Volume change in water
5.9 Ozone resistance
5.10 Optional requirement for type WH
6 Test pieces and temperature
6.1 Preparation of test pieces
6.1.1 General
6.1.2 Samples for determination of hardness
6.1.3 Samples for determination of tensile strength
6.1.4 Samples for determination of compression set
6.2 Test temperature
7 Factory production control
8 Factory product control tests
8.1 Sampling
8.2 Routine tests
8.3 Type tests
9 Storage
10 Designation
11 Marking and labelling
Annex A
Annex ZA
ZA.1 Scope and clauses of the European Standard addressing the essential characteristics of the EU Construction Products Directive
ZA.2 Systems of attestation of conformity
ZA.3 CE Marking
Cited references in this standard
[Current]
Rubber, vulcanized or thermoplastic - Determination of tensile stress-strain properties
[Current]
Rubber, vulcanized or thermoplastic - Determination of hardness - Part 2: Hardness between 10 IRHD and 100 IRHD
[Current]
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures
[Current]
Rubber, vulcanized or thermoplastic - Accelerated ageing and heat resistance tests
One-time Purchase
Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^
$119.17 AUD
Inclusive of GSTFormat *
Web Reader
Licenses *
1 user
Total$119.17 AUD
IMPORTANT