Standard
UPDATE AVAILABLE
AS 3637.1-2005
[Superseded]Specifies general requirements for vertical shaft mine winding conveyance suspension equipment for use in underground mines. Design, materials, manufacture and testing are specified. Appendices provide requirements for 1.5 manganese steel, recommendations for inspection and maintenance, design guidelines for loaded holes and pins, and information on ruling section and equivalent section.
Published: 11/11/2005
Pages: 24
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
Preface
1 Scope
2 Referenced documents
3 Definitions
4 Nominal size
5 Materials
5.1 Type A components
5.2 Type B components
6 Design
6.1 Static design factor
6.2 Fatigue reserve factor
7 Manufacture
7.1 Type A and Type B components
7.2 Type A components—Additional requirements
7.3 Threads and nut locking
7.4 Protective coatings
7.4.1 Type A components
7.4.2 Type B components
7.4.3 Shear pin
8 Testing
8.1 Proof load test
8.1.1 Procedure
8.1.2 Requirement
8.2 Non-destructive test
8.2.1 Purpose
8.2.2 Procedure
9 Test certificates
9.1 Certificates required
9.2 Component certificates
9.3 Assembly test certificate
10 Marking
11 Inspection and maintenance
Appendix A
A1 Scope
A2 Inspection
A3 Frequency of inspection
A4 Inspection after an incident
A5 Maintenance
Appendix B
B1 Scope
B2 General
B3 Ruling section
B4 Equivalent section
Appendix C
C1 Scope
C2 Chemical composition
C2.1 General
C2.2 Cast analysis
C2.3 Residual elements
C2.4 Product analysis
C2.5 Austenitic grain size
C3 Identification
C4 Conditions of supply
C5 Mechanical property and heat treatment requirements for steel components
C5.1 Mechanical properties
C5.2 Heat treatment
C6 Determination of mechanical properties for steel components
C6.1 General
C6.2 Samples for testing
C6.3 Tensile test
C6.4 Impact tests
C6.5 Requirements
C7 Retests
C8 Certificates
Appendix D
D1 Scope
D2 Loaded holes
D2.1 General consideration
D2.2 Static design (see Figures D1, D2)
D2.3 Fatigue design (see Figure D2)
D3 Pins
D3.1 Static design (see Figure D5)
D3.2 Fatigue design (see Figure D6)
Amendment control sheet
AS 3637.1—2005
Amendment No. 1 (2011)
Correction
Cited references in this standard
[Current]
Non-destructive testing — Magnetic particle testing of ferromagnetic products, components and structures
[Current]
Non-destructive testing - Ultrasonic testing of carbon and low alloy steel forgings
[Current]
Carbon steels and carbon-manganese steels — Hot rolled bars and semifinished products
Content history
[Current]
[Superseded]
[Superseded]
AS 3637.1-2005 Rec:2017
DR 05062