Standard
Track updates
iconCreated with Sketch.

AS 1237.2:2016

[Current]

Tolerances for fasteners, Part 2: Washers for bolts, screws and nuts — Product grades A, C and F

Establishes a selection of tolerances for use in the preparation of ISO product standards for punched plain washers of product gradesA and C, for use with bolts, screws and nuts of nominal thread diameters of from 1mm to 150mm inclusive.
Published: 07/09/2016
Pages: 11
Table of contents
Cited references
Content history
Table of contents
Header
About this publication
Preface
1 Scope
2 Normative references
3 Symbols
4 Tolerances
Annex A
Bibliography
Cited references in this standard
[Current]
Geometrical product specifications (GPS) - Geometrical tolerancing - Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR)
[Current]
Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
Content history
[Superseded]
DR AS 1237.2:2016

One-time Purchase

Access via web browser on any device
One-time purchase
Single publication
Offline access via PDF^

$104.71 AUD

Inclusive of GST
Format *
iconCreated with Sketch.
Web Reader
Licenses *
iconCreated with Sketch.
1 user
Total$104.71 AUD
Add to Cart
IMPORTANT